Turning your Aga on - Gas
Mk 2 Burner

Refer to the sketch below to identify the various controls.

1	Before lighting ensure the gas valve knob ‘4’ is set to the ‘OFF’ position (‘O’ symbol)
2	Turn on gas supply externally and at internal service tap ‘1’, i.e finger grip in line with pipe.
3	Press and hold the square button down ‘5’ ( with flame symbol on) and with the other hand press the round ignition button ‘2’ several times, until the pilot flame can be seen to be lit.
4	Continue holding the square button down for at least 30 seconds.
5	Release square button and pilot should remain alight. If it goes out, wait 3 minutes and repeat operation, but hold the square button down for a longer period.
6	With the pilot established, rotate the control knob anti-clockwise to the No.1 position, when the main burner should ignite.
7	Leave in No.1 position for about 1 hour, then slowly turn knob to No. 5 position, which should give the correct amount of stored heat.
8	Note that if the ignitor fails the pilot flame can be lit with a match or taper, after first removing the inspection window. Replace window before turning main burner on.

If problems persist, please call your Aga service engineer.